English  flag_sr

DCS 100 A

DCS 100 A 02

DCS 100 A DCS 100 A


PRICE: 95 €

 

DC SERVO DRIVE WITH ANALOGUE OUTPUT DCS-100-A

DCS-100-A is microcontroller based drive with opto-isolated analogue output ±10V. It is used to drive third party servo amplifiers. DCS-100-A is suitable for retrofit of CNC machines which has robust servo power amplifiers for DC motors with analogue input.
Drive is based on 16-bit microcontroller with implemented PID control algorithm. As the feedback of DC motor position an incremental encoder with phase-shifted square signal (quadrature encoder) is used. Encoder interface enables 1x, 2x and 4x encoder resolution.
Adjustment of all parameters is performed by using the configuration software ServoTune3.
The input control interface enables control via opto-isolated lines in next modes:
- STEP/DIR/ENABLE,
- CW/CCW/ENABLE,
- Encoder follower in 1x, 2x and 4x decoding, and
- Via analogue input within the range 0÷5 V with and without feedback.
- Built-in soft start function enables DC motor 1s after power on in order to decrease power surge on start.
There is an opto-isolated digital output on drive, named Track Error which is activated if preset value of tracking error offset is exceeded. That output can be used for activation of external circuit for DC motor emergency stop.
Use power supply 8÷24 VDC. Drive has reverse polarity protection.
APPLICATION
- CNC machines retrofit
- Coordinate tables
- Positioning
- Robots
- Education



DRIVE OUTLOOK

 

DCS 100 A

Connector positions on drive DCS-100-A.

 

ServoTune3

ServoTune3

ServoTune3 is configuration software for DC servo drives.

NOTE: For adjusting parameters od DCS-100-A use software version ServoTune3 Ver.3.09 or later.

icon zip 32ServoTune3 v.3.09 - September 2015.



 

SPECIFICATIONS

Characteristics Description
Type Closed loop DC Servo drive with opto-isolated analogue output ±10 V and PID control algorithm
Number of axis 1
Input control interface

Digital control modes via opto-isolated lines STEP/DIR/ENA, CW/CCW/ENA and Encoder follower (1x, 2x and 4x)

Analog 0÷5 V with and without feedback
Frequency of STEP command < 600 kHz
Command line pulse width > 0.5 μs
Command line current approx. 10 mA at 5 V
Output Opto-isolated analogue ±10V
Auxiliary outputs

Opto-isolated Tracking Error
Two inverted PWM signals (TTL)
Enable output (TTL)

Feedback Incremental encoder with phase-shifted square signal
Incremental encoder resolution x1, x2 i x4 multiplication, settable by software
Incremental encoder power supply Source on drive +5 V DC / 250 mA
Drive parameter set up Via IDC10 connector and programming interface (IPI-USB or Bluetooth BT-PI)
Power supply 8÷24 VDC, 250 mA – reverse polarity protection
Dimensions (W x L x H) 102 mm x 77 mm x 31 mm
Weight 150 g approx.

NOTE: Specifications are subject to change without notice